Arduino - Momentary Button to Trigger Messages on LCD
$2-8 USD / Stunde
Looking for an Arduino hobbyist to code the following project:
When the Arduino powers up, there is a default message displayed. When the the momentary buttonis pushed it triggers 1 of 2 messages to displayed on an LCD screen for approximately 60 seconds and then it reverts to the default message. When the momentary button is pushed again the second message is triggered and again stays for approximately 60 seconds then goes back to the default.
Ideally it would be great if the default message itself, was rotating between 2-3 messages every 30 seconds. But this is not a requirement.
Please state your experience with Arduino and how quickly you can have the work done.
Thanks!
------- LCD is wired as follows -------
/*
The circuit:
* LCD VSS to GND
* LCD VDD to +5v
* LCD Contrast to resistor + GND
* LCD RS pin to digital pin 7
* LCD R/W pin to ground
* LCD Enable pin to digital pin 6
* LCD D4 pin to digital pin 5
* LCD D5 pin to digital pin 4
* LCD D6 pin to digital pin 3
* LCD D7 pin to digital pin 2
* LCD Backlight GND to arduino GND
* LCD Backlight to >40ohm to +5v
*/
Projekt-ID: #1514306
Über das Projekt
6 Freelancer bieten im Durchschnitt $4/Stunde für diesen Job
Hi, I have more than 3 yrs of experience in using Arduino platform and have done similar application recently. Kindly check your PM Box for details. Thank you. Regards, Tushar