Electric Motor Testing Panel console - To design and sizing up all component list with electrical and panel drawing

Electric Motor Testing Panel console - To design and sizing up all component list with electrical and panel drawing Listed below the functionality of this motor tester console table panel requirement: • Single phase 110 & 230 volts & three phase 380-415 Volts—50Hz • Three & single phase volts & ampere meter with selector switch range low & High ampere scale separate Amp. • Meter one for within0-15amp and one for up to [login to view URL] may use current transformer (CT). • Also use step down transformer for DC supply from 6, 12 & 24 DC voltage max 10amp. Capacity output connection knot enable to connect to motor terminal and selector switch include Ampere & voltage Meter. • Motor ratings--- Single phase max.3 KW motor & for three phase from 0.25 KW to 40KW Motor • Purpose of tests to Check and record the motor running amp. On no load three phase balance record. • Also do a full load test facilities, temperature rise test of induction motor able to direct measurement of Voltage, Current, power PF, apparent power, reactive power, Frequency measurement meter. • DOL starter and star Delta starter • measurement of torque in KG/M,RPM, • Contactors range allow for currents up to 40KW • Tests to be performed for motor coil winding insulation test/ohm reading • Motor stator failure analysis on Coil winding type of defect indication by this test show report of short circuit by two phase or coil short to earth, or overload amp operation cause motor coil winding burnt off. • Productivity requirements—this tester panel can be movable with trolley by plug in the power supply from designated area and power point outlet. • Then connect to the motor to carry QC test after assembly and fault finding check/analysis record. • The console must finish with suitable flexible cable with cable connection socket or knot both tester console to motor terminal. @ Dear Engineers - Please share your proposal.