CAD Design, Ready for 3D Print & Molds

-- THIS IS ADULT PRODUCT, IF HAVE PROBLEM, DO NOT BID, THANKS! -- LOOKING FOR ONLY THOSE THAT ARE NOT BUSY. IF YOU HAVE FREE TIME, TYPE IN "FIRST DRAFT PROVIDED IN 3 DAYS ON MAIN DEVICE" IN YOUR BID....and please note, after accepting job and discussing ALL points of discussion, I DO EXPECT first draft preview in 3 days :-) Taking the files from the 3D Render Designer made in Maya and need to - add - modify - prepare files for 3d printing - prepare files for mold making These are the parts. - MAIN DEVICE - SILICONE PART - CAP FOR MAIN DEVICE - HEAD SET - REMOTE CONTROLLER - DESK MOUNT --- I will provide you with my tinkerCAD screenshots and reference points on a lot of the mentioned below. --- - Main Device -- clean up device, make all surface smooth and all outer housing parts flush -- the top window/door needs to add a latch and feet at end so can be functional in terms of clipping in, easily removing it, but still flush with the outer housing. Doesn't stick out. -- the rear, battery cover, same thing, add latch and feet on cover so can be functional -- inside plastic piece holding the pcb, battery and motor. Needs be designed from scratch, so can universally fit the 4 different motors. I will provide you the motor specs so you know how to position them centered. -- adjust the poles and receiving holes on each side because the front entry part has two rectangle slits/holes/empty spacing... -- add clips to ensure the top and bottom housing snaps together. -- add columns on each end, so we can screw the end plastic + rear plastic to ensure the unit holds together strongly -- the read lining is suppose to be a separate piece of plastic that snaps on. More less an designer piece so the product doesn't look boring. - Silicone sleeve -- need redesign to make the silicone thicker in radius + adjust the plastic all-around it according to the size you make it to. For example, now it is, I think, 40cm...I'd like it to be 50cm overall radius with maybe to inner hole sizes (one 15cm and another 30cm) - Cap cover -- to ensure it will snap on and off which can do so easily 1000+ times without losing it's firmness - VR Headset -- design all parts so they fit, can be assembled nicely ---will provide detailed images of a competitor headset taken apart, piece by piece -- need to have a cable brought from front to each side. Purpose is so we can make a Y shape cable that will connect to a "adapter" on each side the ear. So our consumers can plug in earbuds. But then on front, where user places their mobile phone, can plug in the cable into their phone. - Remote Controller -- must have toggle -- must have 4 buttons on top, behind toggle. Top right is beveled in, every other button to have a small bump, beveled out. -- must have 2 buttons in front, by the front end. The bottom button is curved like towards your finger. The top button just arched (semi rounded) button. ----will provide detailed images of one I like with features described... - Desk Mount -- this will connect with two suction cup parts. -- needs to be designed so there is a top piece and a bottom piece. -- top piece has 4 columns. bottom piece has 4 holes. They will be assembled through the use of screws. -- the top piece, front part, will connect to the base of the main device through sliding in. ----need to design with perspective to sizing of the main device fittings, so can easily sliding in and out, but not loose and not too tight... Some more additions or modifications may need to be added. Winning bidder agrees to offer up to 90 days support to make minimal adjustments, additions or modifications as we need, all within reason.