I'm looking for someone who can design and build a 3-watt 8 ohm amplifier based on the Nelson Pass Zen headphone amplifier with NJW1194 transistor for volume and tone controls. Power supply must be AC Regenerated like the Monarchy Audio AC Regenerator. Bid must include all parts and labor
I need you to design a programable NMEA buffer PCB. It should be in 122mm x 110mm. PCB should receive RS-422 data and convert it to CMOS using transistors and opto couples and receivers. Outputs RS-422 data to multiple device. All input, output and power ports should be galvanic isolated from each other. Electrical connections should be according to
...ANTENNA AZIMUTH ANGLE CONTROL USING QFT.. The system is a Multi Input and Multi Output.(MIMO) SERVO CONTROL SYSTEM. This can be done on MATLAB by using SIMULINK. QFT (Used to design Controller and Pre-Filter) Quantitative Feedback Theory (QFT) is for robust stability, tracking and disturbance rejection. The constraints applied over certain intervals are
A lab. eq...three voltages (up to 10V and 8mA) using an integrated motor driver, and I need to amplify the signal (8mA is too low) to run the brush less motor. I need someone to design the amplifier and create the PCB in eagle or Altium. I will make the prototype to test it. Please see attachment for diagram and let me know if you have any questions.
a speaker (amplifier) has an AUX cable. And the volume control by an IR remote and play and pause.