Aurdino programing
$30-250 USD
Bezahlt bei Lieferung
Aurdino closed loop code needed for servo (brushed or brushless DC motor).
Servo motor spins at 3000 RPM draws 10A @ 14 V.
Rotary encoder on shaft.
Servo position accuracy is +-180° shaft degrees.
Controller gets input from Hall RPM sensor mounted on the clutch.
Servo controls distance between CVT pulleys.
If clutch RPM<1000 then servo stays in zero position.
When clutch reaches 1000 RPM servo starts to move the pulley.
Max. speed of the clutch is 2000 RPM when servo has to be in end position.
Servo rotates proportional to the clutch RPM change.
When clutch RPM changes for 1 RPM servo motor should rotate 2,5 revolutions.
Servo motor makes 250 revolutions between end positions.
Servo gearbox is self locking, there is no need to power the servo to hold position.
Projekt-ID: #8399174
Über das Projekt
16 Freelancer bieten im Durchschnitt $197 für diesen Job
hi sir i am an expert arduino programmer i can do it for you i have almost 7 years of experience. in this field i have read the details and understand your system fully please reply to discuss it further i am ready to Mehr
I am an Electrical Engineer having specialization in Electronics and Control, teaching in Electrical Department FAST National University Pakistan. I am also continuing my MS degree in Electrical Engineering with specia Mehr
Hello, have a nice day. My name is Shahbaz Ali. Iam heading an R&D (Research and Development setup). We will help you in writing the sketch and to run the system. Please feel free to contact. Best Regards, Shahb Mehr
I am working on arduino uno currently so this project can be completely by me as per your requirement
I worked in a same project. Thats mean i can finish your project quickly and with good quality. I wish you the best. Best Regards, Josef
