CAD/CAM work done

What we would need on this end to save time: 1. Add 3 .020 breakaway holes on each part so that the individual parts will be secure in the panel after routing. The parts will be broken out by hand, so use as few tabs as possible. 2. Create the .080 tab breaks in the outline for each part and create the route program, using .062 router bit with outside compensation. Some of the parts will be spaced smaller, and if so, we can use as small as .020, .031 or .040 router bits. Most of the parts are .100 apart, so .062 bit is preferred!! Some parts on the board outline layer may have .100 or .094 lines being used for the board outline, we would then use .100 or .094 router bits, with no comp. Slots and cutouts may be used on some of the parts, and these would need to be included in the route program. Slots with copper on the top and bottom layers will be plated thru, and we would create this program, all other slots will need to be in the route program.