Engine RPM Read with CAN BUS SAE J1939 STM32F103

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in embedded design & programming using pic, dspic controllers and MATLAB codding for Power projects, Boot loaders, Bluetooth & GPS designs,CAN communication, EEprom. UART , RF circuits ,Protocols for networking, wi-Fi routers,OBD diagnosis with CAN bus protocols, Electrical vehicles and AC drives, stepper motor controls. I designed sine wave inverters for standalone and grid tie Inverters. I designed projects like Off line UPS up to 3 KVA, 5kW motor controller for electrical vehicles ,synchronous rectifiers, Solar MPPT chargers, Solar trackers, Battery chargers ,Grid tie inverters design with PLL and feedback control circuit emergency light of 66W and Online UPS control cards, Battery Charging power supplies, LED drivers for PWM controlling and dimming, SMPS, Power supplies. I have experience in schematics and PCB design experience in Altium and ORCAD. I am ready to work for you. Please contact for further discussion.

I can provide a rapid/quick working project with STM32F103 board and CAN. I am very knowledgeable about J1939/J1708 Standards and CAN data requests. Worked with Single Wire/High Speed CAN transceivers and CAN data analysis. Please provide Schematic

Hi, i am kahan. I am embedded engineer and have much experienced in hardware and software side. Waiting for further discussion. Thank you

I am working in this Automotive Embedded development for last 7 years. having a track record of 100& success rate.

Hello, my name is Fernando Blaha. I am very experienced and familiar with both, STM microcontrollers, it's CAN peripheral, and vehicle CAN bus, including J1939, IESCAN (Mercedes Benz) and OBDII. I hope we can get this job to show you my aptitudes, and probably continue working in the future. Thank you Fernando Blaha