PCB design and programming

*Components will include PCB, IR (Emmitor- detector), a small microprocessor, power transistor to drive a relay, A dual-color LED, and the circuit will communicate with a mega Arduino via I2C protocol. *small program to operate the PCB. *the body form will be a hole disk with 30 mm out diameter the hole dia is 10mm and with a good design. 1- we want a PCB circuit with 30 mm out diameter and a central hole of 10 mm 2- this circuit have at one face IR transmitter and IR receiver and BI-LED 3- this circuit will have at another side the other components the circuit work is to: 1- work independently and comunicate with the main circuit in some times and in some textile machins may we use only the circuit without the main unit 2- use an encrypted IR beam to avoid the outer confusion 3- when the IR beam cuts for time T1 the relay must actuate for time T2 4- when the IR cut for time T3 the relay must actuate for time T4 5- T1, T2 , T3 ,T4 is adjustable by program 6- our circuit can tell the main circuit via I2C protocol that it is actuate or not 7- the main circuit can command our circuit via PCB protocol to actuate the relay for time T3 or T4 8-The Bi-LED doesn't connect to any another component of the circuit and have its own socket because it will work with another circuit 9- the sockets have to arranged as in diagram two I2C pins separately four pins in another socket the first +v second NO third NC fourth 0v the Bi-LED must locate as close as possable to the central hole the IR components must locate at the ends of the circuit circle diameter facing each other Please quote for just schematic and also PCB layout. Looking to start immediately. Thanks! Skills: PCB Layout, Electronics, Product Design, Electrical Engineering, Schematics Welcome to 0 reviews Deadline 2 days